DeleteMe cube

This is a cube that someone forgot to remove. It clearly shows bright colors, but that didn't stop it from going unnoticed.
Being able to observe one is a rarity that must be earned.

Content: The kit consists of several pieces to assemble:
  - A magenta cube
  - Two yellow rectangles
  - Four yellow bars
  - Six copies of black "DELETE ME" letters
Dimensions (in cm): Length: 3.3 / Depth: 3.3 / Height: 3.3.
Filaments used:

Glue is required in several places during assembly.
A: cube / B: letters / C & D: rectangles / E: bars

Start by separating the letters B from their supports, then insert them into the holes of cube A.
If the letters fall out when turning the cube over, you will need to add a dot of glue to hold them in place.
If you cannot insert the letters easily, cover them with a cloth to avoid leaving marks on the cube, then push them in by applying a small force to them with a flat object (see video).
Do not hesitate to trim the edges of the holes and letters a little with a knife to increase the gaps. The letters 'D' and 'M' are often more complicated than the others to insert.

Put rectangles C and D on two opposite faces of cube A.
Free bars E from their supports, then apply a small dot of glue to their two ends.
Then place the bars E between the rectangles and wait for the glue to set.
If necessary, also apply glue to the four corners of the rectangles to stick them to cube A.

Assembly video

Some contours on the lower face are supported, so they will be less straight. You may consider flattening them before placing the bars or rectangles.
The lettering on the side faces is not supported as it was impossible to remove supports without damaging the cube. The hanging parts of the letters will then sag slightly.

Horizontal lines may appear on side faces.

The faces will have three slightly different renderings on the top, bottom, and side faces.

The top and bottom faces of the letters will not have the same texture.
It is recommended to keep the same orientation for all letters during assembly.

All parts will undergo a quality control inspection before being sent.