Construction sign

The construction sign marks the end of a path, or the start of a new adventure.
A fairly rare sighting, which has all the qualities required to be a good Placeholder.

Content: The kit consists of 6 pieces to assemble:
  - Two brown posts
  - Two red and gray lamps
  - Two yellow and black bars
Dimensions (in cm): Length: 7.1 / Depth: 1.6 / Height: 4.8.
Filaments used:

No glue required.
A: left post / B: right post / C: bottom bar / D: upper bar / E & F: lamps

Take post A with the hole on the top and insert bar C in the bottom holes. Then start again with bar D above it.
Make sure to insert the bars to the end of the holes, the orientation must correspond with the other side of the post.
Then add post B with the hole at the top. If necessary, re-orient the bars slightly so that they fit into the opposing holes.
Finish by firmly pressing the two posts together.

All that remains is to insert the lamps E and F into the holes.

To go a little further if you have a labeler, it is possible to add a little sentence on the upper bar.

Assembly video

Hanging parts need supports to be printed. The interfaces between the supports and the parts will be visible.

The walls of the posts appear lighter in the thinner parts of the posts where the holes are located. Layer lines may also be visible there.

Lamp edges are not supported to avoid artifacts. But their angle means that they can sometimes be less precise.

All parts will undergo a quality control inspection before being sent.